About This Bass Booster
Guitar Tool Hub's free online bass booster (a bass and treble equalizer in one) makes any song, recording or backing track bass boosted, entirely in your browser. Load an MP3, WAV, M4A, OGG or FLAC file, drag the Bass slider up to +24 dB (or down to −12 dB to tame a boomy mix), and pick where the boost starts: Sub at 60 Hz for kick and 808 rumble, Deep at 100 Hz for most music, Punch at 150 Hz for bass guitar, or Warm at 250 Hz for a fuller low end. A treble shelf above 6 kHz and a volume control complete it, and a live EQ curve shows exactly what the settings do to each frequency. Bass carries most of a song's energy, so boosting it pushes the peaks past full volume, which a plain bass booster lets crackle; this one runs the same look-ahead limiter as the MP3 Volume Booster, holding peaks at −1 dBFS, and offers a one-tap Fit volume when the limiter has to work too hard. The bass level, loudness and peak are measured before and after, and you can switch between the original and bass boosted versions while the song plays. Download a 192 kbps MP3 or a lossless WAV. Nothing is uploaded.
- 01Boost the bass of any song or audio file by up to +24 dB (or cut it by up to 12 dB)
- 02Four bass frequencies: Sub (60 Hz), Deep (100 Hz), Punch (150 Hz), Warm (250 Hz)
- 03Treble control (−12 to +12 dB above 6 kHz) for a two-band bass and treble equalizer
- 04Live EQ curve showing exactly what the settings do to each frequency
- 05Clipping protection: a look-ahead limiter holds peaks at −1 dBFS so bass boosted audio does not distort
- 06One-tap "fit volume" when the limiter is working too hard
- 07Bass level, loudness (LUFS) and peak, before and after
- 08Switch between the original and the bass boosted version while it plays
- 09Download as MP3 (192 kbps) or lossless WAV
- 10Runs entirely in your browser — the file is never uploaded
How to Bass Boost a Song Online
Load your song
Drag an MP3, WAV, M4A, OGG or FLAC file onto the bass booster or tap to choose it. It is decoded and measured locally in your browser.
Boost the bass
Drag the Bass slider or tap a preset (+4 to +24 dB), then pick where the boost starts: Sub 60 Hz, Deep 100 Hz, Punch 150 Hz or Warm 250 Hz.
Adjust treble and volume
Optionally add or cut treble above 6 kHz, and set the output volume. If the limiter is working hard, press Fit volume.
Listen and compare
Press play and switch between Original and Bass boosted while it plays. The bass level, loudness and peak readings update as you change the settings.
Download
Choose MP3 (192 kbps) or lossless WAV and press Download.
Frequently Asked Questions
Load the song into the bass booster, drag the Bass slider up (or tap a preset such as +10 dB), and choose where the boost starts: Sub (60 Hz) for kick and 808 rumble, Deep (100 Hz) for most music, Punch (150 Hz) for bass guitar, or Warm (250 Hz) for a fuller low end. Press play and switch between Original and Bass boosted to compare. Leave Prevent clipping on, then choose MP3 or WAV and press Download. Nothing is uploaded.
For music that just sounds thin, +4 to +6 dB at 100 Hz is usually enough. +10 dB is a strong, obvious boost, and +15 to +24 dB is the deliberately over-the-top "bass boosted" sound. Watch the Limiter readout: a big bass boost on a song that is already loud makes the limiter turn the whole track down on every kick, which can sound like pumping. If it warns you, press Fit volume, or use less boost.
Bass carries most of a song's energy, so boosting it raises the peaks far more than boosting treble would. A finished song already peaks close to 0 dBFS, the most a digital file can hold, so even +6 dB of bass pushes it over and the tops of the waveform get cut off, which sounds like crackling or farting speakers. With Prevent clipping on, a look-ahead limiter holds the peaks at −1 dBFS instead. Your own speakers or headphones can still distort at high volume with heavy bass; that is the speaker, not the file.
Sub bass is roughly 20 to 60 Hz (the rumble you feel more than hear), bass is about 60 to 250 Hz (kick drums, bass guitar, the low notes of a piano), and the low mids run from 250 to about 500 Hz. The bass booster is a low shelf: everything below the frequency you choose gets the full boost, and the boost fades out above it. The EQ curve on the page shows exactly where.
It is a two-band equalizer, the bass and treble controls of a car stereo or hi-fi: a bass shelf with four corner frequencies and a treble shelf above 6 kHz, plus a volume control. It is not a multi-band graphic equalizer. To EQ several tracks separately, the Online Audio Mixer has a 3-band EQ on every track.
Saving as MP3 re-encodes the audio once at 192 kbps, which is transparent for most listening but is one more generation of lossy compression. If you will edit the file further, download WAV instead; it is lossless. The boost itself adds no noise, but it cannot add bass that is not in the recording: a phone recording or a cheap MP3 with little real low end will mostly get louder rumble and hum.
Yes. A DI or phone recording of an electric guitar often sounds thin; +3 to +6 dB at 150 or 250 Hz adds body without muddying it. For a bass guitar recording, try Punch (150 Hz) for growl or Deep (100 Hz) for weight. To bring a quiet recording up to the level of a finished song afterwards, use the MP3 Volume Booster.
No. This tool makes a bass boosted copy of an audio file that you load and then download. To boost the bass of everything your device plays, use your phone's equalizer settings, a system equalizer app or a browser extension. To bass boost one song so it plays that way everywhere, this is the tool.
No. Decoding, filtering, limiting and exporting all run locally in your browser using the Web Audio API. Your file is never sent anywhere, and the original is not changed. You download a new, bass boosted copy.
Yes, completely free. No account, no app to install, no watermark and no file-size paywall.